neil Posted 7 March 2003 Share Posted 7 March 2003 Depends on the quality of your equipment mate I appreciate that technical/CAD drawings are not going to be the best scanned but if they were going to be photocopied and posted then there is very little difference Link to comment Share on other sites More sharing options...
Guest GovTModel Posted 9 March 2003 Share Posted 9 March 2003 I don't have a scanner One of my friends does, however, and she will scan the drawing for me next week. Link to comment Share on other sites More sharing options...
neil Posted 9 March 2003 Share Posted 9 March 2003 I don't have a scanner One of my friends does, however, and she will scan the drawing for me next week. It was just a thought Richard If that fails, send it to me and I'll scan it Link to comment Share on other sites More sharing options...
Guest Posted 19 March 2003 Share Posted 19 March 2003 http://cgi.ebay.co.uk/ws/eBayISAPI.dll?Vie...67&category=135 Just found this on Ebay. Could provide a good pattern for the job. 45 & 47 thou seems a bit excessive though (even for an old magazine feeder)... Link to comment Share on other sites More sharing options...
Guest GovTModel Posted 21 March 2003 Share Posted 21 March 2003 I have the drawings for headspace gauges as a jpg file, ~3Meg. Email me off-line if you want a copy. Link to comment Share on other sites More sharing options...
neil Posted 22 March 2003 Share Posted 22 March 2003 I have the drawings for headspace gauges as a jpg file, ~3Meg. Email me off-line if you want a copy. Richard sent me the file and I have it down to a 15kb .gif file which I believe shows in just as much detail as the original I was sent Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now