gordon

Thanks for the advice Huey, I will run a few rounds through it at different  settings ,I have different batches to try so I'll see what develops. 
 
Regards
Gordon. 

Bit of brain fade I think Tim, should have been Lilja barrel
Anyway it begins with" L" and ends in "a".

Hi Huey,  5nm on the front two and 5.5nm on the rear two.
These were the settings that the chap who I bought the rifle from recommended.
At the moment I'm getting flyers into the 9 ring .The rifle has a stainless steel  Lilja  barrel and a Fat One tuner and sits in a bedded/pillared Cicognani BR stock ,the flyers are in the horizontal ,not vertical plane.
So the torque wrench was to make sure I was getting the correct torque on the four bolts (Anschutz 2013 ) And be able to try different settings if necessary?
Regards, Gordon .

Thanks for that Huey, I've looked at a few , I need one that I can I finely adjust , most of the ones I've seen, its very difficult to get spot on the same settings each time .
I have an Anschutz 2013 action with the four stock bolts ,its quite fussy on torque settings ,so thought /hoped that the AHG one would be easier to adjust ?
Regards
Gordon .